4.2 Operations
4-7
6
When the parameters were read out from
the specified block in digital operator,
and saved in the SERVOPACK, “Com-
pleted” is displayed.
And A.941 “Change of Parameters
Requires the Setting Validation” is dis-
played.
7
When the parameters were written and
saved, “Completed” is displayed, and
then the parameter block selection dis-
play appears.
8
Press the
Key.
The display returns to the parameter copy
mode menu display.
Turn OFF the power and turn ON again
to clear A.941.
(cont’d)
Step Display after Operation Keys Operation
00:SGDV− R70
Completed
A. 941 − OP→ SERVO−
00:SGDV− R70
01:∗∗∗∗
02:∗∗∗∗
03:∗∗∗∗
A.941 − OP→ SERVO−
1:SERVO→ OP
2:OP→ SERVO
3:VERIFY
4:LIST
A.941 − COPY−
To Next Page
Loading...
