YASKAWA JUSP-OP05A-1-E - Page 141

4
Parameter Copy Mode
4.2 Operations
4-11
(2) Notes on Verify Parameters Function
• If an empty block (“
∗∗∗∗
”) is selected and the verify function is executed, the mes-
sage “No Data” is displayed, and the verification will not be executed. Press
the Key to return to the parameter block selection display.
• Pressing the Key to cancel the operation while verifying parameters. “Can-
celed” is displayed, and the display returns to the parameter block selection dis-
play.
• During verification operation, the executing process is displayed sequentially as
shown below. The verification takes about 10 seconds.
• If parameter matching is executed with a parameter block that differs from the
model of the SERVOPACK, the message “unmatched parameters” will appear and
matching will not be executed.
Operation cancelled
BB –VERIFY–
Canceled
00:∗∗∗∗
While reading the parameters from
the digital operator
Operation completed
In verification process
00:SGDV–R70
Reading
Parameters..
<< OP >>
BB –VERIFY–
BB –VERIFY–
Verifying
Parameters..
00:SGDV–R70
<< OP–SERVO >>
BB –VERIFY–
00:SGDV–R70
Completed