YASKAWA MH SIGMA-5 Series - Headstock Assembly Mounting Hole Pattern - MH95;185;505;1605

4-3
162068-1CD
162068-1CD
MH-SERIES
POSITIONER
4 Installation
4.2 Installing the MH-Series SIGMA-5 Positioner – Type I
4.2.3 Headstock Assembly Mounting Hole Pattern –
MH95/185/505/1605
The headstock assembly may be mounted to the column assembly (see
Section 4.2.4) or mounted to a customer-supplied machine base. For
custom orientation auxiliary mounting holes are provided on top of the
drive assembly housing, and may be used in addition to the base
mounting holes. Table 4-4 shows mounting specifications for positioners.
The following figures show the mounting hole patterns;
• Fig. 4-11 shows the mounting hole pattern for the MH95/185.
• Fig. 4-12: shows the mounting hole pattern for the MH505.
• Fig. 4-13 shows the mounting hole pattern for the MH1605.
Fig. 4-11: MH95/185 Mounting Hole Pattern
Table 4-4: Mounting Specifications for Positioners
Drive Assembly Bolt Size, Grade SHC Tightening Torque
(N•m/lbf-ft.)
MH95 M10 44/32
MH185 M10 44/32
MH505 M10 44/32
MH1605 M16 162/122
260.0
52.5
20
104.5
320.0O
140.0
60.0
12.5
273
SWITCHES & BRACKETS NOT SHOWN
FOR CLARITY
2X M10 X 1.5 THRU HOLES
FOR ADDITIONAL MOUNTING
SUPPORT AS REQUIRED FOR
SPECIFIC APPLICATIONS.
4X Ø 11.0 THRU
+ 0.5
- 0.0
52.5
2X Ø 10.0 THRU
+ 0.015
- 0.0
29/101