YASKAWA MH SIGMA-5 Series - MotoMount HD Adjustments

4-25
162068-1CD
162068-1CD
MH-SERIES
POSITIONER
4 Installation
4.6 MotoMount HD Adjustments
4.6 MotoMount HD Adjustments
MotoMount HD is used on the MH1605 (Type I), and MH3105 (Type II)
drive assemblies.
The MotoMount components are delivered assembled to the headstock
and tailstock assemblies. See Section 4.4 for installation of the headstock
and tailstock assemblies.
Fig. 4-34: Nominal Center Position - Side View
4.6.1 Allowable Misalignment
The flexibility of MotoMount allows for misalignment between the tailstock
and the tooling fixture without affecting performance. A total misalignment
(combined tooling and headstock/tailstock) up to two degrees, from top
view is permissible. If misalignment exceeds two degrees, check tooling
and/or position of tailstock.
Fig. 4-35: Allowable Misalignment - Top View
22 MM
29 MM
TAILSTOCK
COLUMN
TOP
ADAPTER
CLAMP
ADAPTER
SHAFT
TAILSTOCK
ADAPTER
TAILSTOCK
COLUMN
TOOLING
FIXTURE
TAILSTOCK
ADAPTER
TOOLING
FIXTURE
2 DEGREES
51/101