YASKAWA MH SIGMA-5 Series - Customer-Supplied Tooling Fixture

5-2
162068-1CD
162068-1CD
MH-SERIES
POSITIONER
5 Tooling Recommendations
5.1 Headstock Only – Tooling Recommendations
5.1.1 Customer-supplied Tooling Fixture
The customer-supplied tooling hangs from the faceplate as it supports
production parts for welding. Customers control/change the design of
tooling fixtures to match the design of the production parts.
5.1.1.1 Recommendations
To ensure optimum performance from the customer-supplied tooling
fixture, please read the following recommendations:
• Use all bolt holes on the faceplate to mount the tooling fixture.
• Use the dowel pins.
5.1.1.2 Mounting Holes – Faceplate
The customer-supplied tooling must be designed to fit the MH-SERIES
POSITIONER faceplate mounting holes. See the following figure for the
faceplate mounting hole pattern;
• Figure 5-39 for MH95/185 faceplate
• Figure 5-40 for MH505 faceplate
• Figure 5-41 for MH1605 faceplate
• Figure 5-42 for the 3105 faceplate
Fig. 5-39: Mounting Holes on Faceplate MH95/185
100.0 MM
80.0 MM
80.0 MM
100.0 MM
100.0 MM 100.0 MM
4 X 12 X 1.75
18 MM DEEP
2 X SLIP FIT FO
R
M12 DOWEL
320.0 MM
55/101