8.1 Protection Through Security Mode Settings
8-5
Changing the Security Mode
GUN CONDITION AUX Management Management
WELDER CONDITION Management Management
GENERAL GENERAL DIAGNOSIS Operation Edit
PAINT PAINT SYSTEM Management Management
PAINT DEVICE Management Management
CCV-PAINT TABLE Management Management
PAINT CONDITION
Operation Edit
Operation Explanation
1 Select {SYSTEM INFO} under
the main menu.
The main menu is shown.
Note: Icons for the main menu such as arc welding system differ
depending on the system being used.
2 Select {SECURITY}. The selection window of security mode is shown.
Menu & Security Mode
Main Menu Sub Menu
Allowed Security Mode
DISPLAY EDIT
DOUT
MOVE
END
In Out
B001
CF
FLOPPY DISK/Compact Flash
DEVICE
FC1
FC2
PC CARD
Main Menu
PARAMETER
Turn on servo power
EDIT
DISPLAY
UTILITY
MONITORING TIME
ALARM HISTORY
I/O MSG HISTORY
VERSION
SECURITY
SETUP
DATA
JOB
IN/OUT
SYSTEM INFO
ARC WELDING
VARIABLE
ROBOT
FD/PC CARD
DOUT
MOVE
END
In Out
B001
CF
JOB
IN/OUT
SYSTEM INFO
ARC WELDING
VARIABLE
ROBOT
FD/PC CARD
Main Menu ShortCut
PARAMETER
Turn on servo power
EDIT
DATA
DISPLAY
UTILITY
SECURITY MODE
SETUP
MODE
EDITING MODE
To Next Page
Loading...
