8.1 Protection Through Security Mode Settings
8-6
8.1.2 User ID
User ID is requested when Editing Mode or Management Mode is operated.
User ID must be between 4 characters and 8, and they must be numbers and symbols (“0 to
9”,“-” and “.”).
Changing a User ID
In order to change the user ID, the NX100 must be in Editing Mode or Management Mode.
Higher security modes can make changes the user ID of to lower security modes.
3 Press [SELECT] and select
"SECURITY MODE."
4 Select "SECURITY MODE." The user ID input window is shown.
5 Input the user ID.
6 Press [ENTER]. The input user ID is compared with the user ID of the selected
security mode. When the correct user ID is entered, the security
mode is changed.
Operation Explanation
Main Menu ShortCut
JOB
DOUT
MOVE
END
IN/OUT
In Out
SYSTEM INFO
ARC WELDING
VARIABLE
B001
ROBOT
PARAMETER
CF
FD/PC CARD
Turn on servo power
EDIT
DATA
DISPLAY
UTILITY
SECURITY MODE
MODE
OPERATING MODE
SETUP
EDITING MODE
MANAGEMENT MODE
Main Menu ShortCut
JOB
DOUT
MOVE
END
IN/OUT
In Out
SYSTEM INFO
ARC WELDING
VARIABLE
B001
ROBOT
PARAMETER
CF
FD/PC CARD
Turn on servo power
EDITDATA
DISPLAY
UTILITY
SECURITY MODE
SETUP
MODE
PASSWORD=
At the factory, the following below user ID number is
preset.
• Editing Mode:[00000000]
• Management Mode:[99999999]
SUPPLE
-MENT
To Next Page
Loading...
