8 YASKAWA ELECTRIC TOBP C730600 37B 1000-Series Option PG-X3 Installation Manual
3 Receiving
3 Receiving
Please perform the following tasks upon receipt of the option:
• Inspect the option for damage.
Contact the shipper immediately if the option appears damaged.
• Verify receipt of the correct model by checking the model number printed on the name
plate of the option. (Refer to Figure 1 on page 9 for more information)
• Contact your supplier if you have received the wrong model or the option does not
function properly.
◆ Option Package Contents
◆ Tools Required for Installation
• A Phillips screwdriver (M3 metric / #1, #2 U.S. standard size) is required to install the
option.
• A straight-edge screwdriver (blade depth: 0.6 mm (1/32”), width: 3.5 mm (1/8”)) is
required to wire the option terminal block.
• A pair of diagonal cutting pliers.
• A small file or medium-grit sandpaper.
Note: Tools required to prepare option cables for wiring are not listed in this manual.
Description: Option Ground Wires Screws (M3) Installation Manual
–
Quantity: 1231
PG-X3
MANUAL
To Next Page
Loading...
