• Do not change any wiring while power is being supplied.
• Wiring and inspections must be performed only by qualified engineers.
• Check all wiring and power supplies carefully.
E-9
Wiring Precautions
There is a risk of electric shock or injury.
There is a risk of electric shock or product failure.
Incorrect wiring or incorrect voltage application to the output circuits may
cause short-circuit failures. If a short-circuit failure occurs as a result of any of
these causes, the holding brake will not work. This could damage the machine
or cause an accident that may result in death or injury.
• Observe the precautions and instructions for wiring and trial operation pre-
cisely as described in this document.
Failures caused by incorrect wiring or inc
orrect voltage application in the
brake circuit may cause the SERVOPACK to fail, damage the equipment, or
cause an accident resulting in death or injury.
Continued on next page.
To Next Page
Loading...
Need help?
General
