5 Installation Procedure
32 YASKAWA ELECTRIC TOBP C730600 95A U1000-Series Option PS-U10 Installation Manual
2.
Connect the option into position with the included screws and studs.
Figure 25
Figure 26 Connect the Option
3.
Connect one end of the included connection cable B to CN1 on the option. Connect
the other end to CN19 on the drive.
NOTICE: Put the cable connector in the correct position to connect it to the drive and option. An incorrect
connection can cause damage to the connector and the drive.
Figure 26
Figure 27 Plug the Connection Cable
Note: Tie the connection cable with cables around the two spots shown in Figure 27 using cable ties.
Tie the connection cable with the blue ground calbe at the option side.
CN1
Cable tie
CN19
Cable tie
TOBP_C730600_95A_2_0_E.fm 32 ページ ２０２３年２月１３日 月曜日 午後１時８分
To Next Page
Loading...
