5 Installation Procedure
YASKAWA ELECTRIC TOBP C730600 95A U1000-Series Option PS-U10 Installation Manual 35
2.
Connect the option into position with the included screws and studs.
Figure 28
Figure 30 Connect the Option
3.
Connect one end of the included connection cable C to CN1 on the option. Connect
the other end to CN19 on the drive.
NOTICE: Put the cable connector in the correct position to connect it to the drive and option. An incorrect
connection can cause damage to the connector and the drive.
Figure 29
Figure 31 Plug the Connection Cable
Note: Pass the connection cable under the other cables at the area shown in Figure 31. Tie the
connection cable with cables around the two spots shown in Figure 31 using cable ties.
Cable tie
Cable tie
Pass the connection cable C
under the other cables.
TOBP_C730600_95A_2_0_E.fm 35 ページ ２０２３年２月１３日 月曜日 午後１時８分
To Next Page
Loading...
