5 Installation Procedure
38 YASKAWA ELECTRIC TOBP C730600 95A U1000-Series Option PS-U10 Installation Manual
2.
Connect the option into position with the included screws and studs.
Figure 31
Figure 34 Connect the Option
3.
Connect one end of the included connection cable B to CN1 on the option. Connect
the other end to CN19 on the drive.
NOTICE: Put the cable connector in the correct position to connect it to the drive and option. An incorrect
connection can cause damage to the connector and the drive.
Figure 32
Figure 35 Plug the Connection Cable
Note: Tie the connection cable with a cable connected to the LED around the two spots as shown in
Figure 35 using cable ties.
Cable tie
Cable tie
TOBP_C730600_95A_2_0_E.fm 38 ページ ２０２３年２月１３日 月曜日 午後１時８分
To Next Page
Loading...
