EXAMPLE :
Shown below is a display example in which
the life of the group
!!12!! tools has expired.
TOOL LIFE CONTROL
01234 N1234
TOOL GROUP 12 (LIFE7890MIN.)
TIMER 7890 MIN.
T0404; END
T0808; END
T101O; END
T1212; END
T1414; END
RD Y
Shown below is a display
example in which “ 12” is
set as the tool replacement
completion group number in–
put and the tool replace-
ment completion input is
“closed” after replace–
ment of all tools .
TOOL LIFE CONTROL
01234 N1234
TOOL GROUP 12 (LIFE7890MIN.)
TIMER
OMIN. )
T0404;
T0808;
T101O;
T1212;
T1414;
RD Y
(5) Supplementary explanation for tool life
control
a.
The tool lifecontrol in which multiple tool
offset memories are used by a single tool
is performed as follows:
(i) Make specification as follows by the use
of the part program for tool information
registration:
‘“i”
G123 ;
Elm:
Tool number
A A : Tool offset
memory number
As
shown above,
consecutively specify
the
tool numbers to be used and the off-
set memory numbers in the group to be
specified by address p.
Up to 5 offset
memories may be -used for one tool.
EXAMPLE :
—
G122 ;
P1 L7890 ;
TO1O1 ;
TO1ll ;
T0121 ;
T0131 ;
T0141 ;
T0202 ;
T0212 ;
T0222 ;
T0232 ;
T0242 ;
P.. . L.. . ;
)
G123 ;
—
This is the display of tool lifecontrol
group No.
1 of COM function on CRT
screen at registration of tool information
by the execution of the above program.
129
To Next Page
Loading...
