YASKAWA yasnac lx3 - Page 139

There are following restrictions:
. The tool number used is 01 to 30.
. The tool coordinate memory number
be used for each tool is as follows:
Table 2.26
Tool No.
Tool Coordinate
Memory No.
01
51
02
52
03
53
Note:
IIRegistration of tool information not
from the part program but by the writing
of settings” and “the presetting of the num-
to
ber of tools by settings” are provided for
special operations.
However, these oper-
ations should n~t be performed in principle.
(6) List of Settings for Tool Life Control
a.
Registration of group number for each tool
Table 2.27
Setting
No.
*86r)l
Contents
I
Remarks
I
I
30
w
(iii) When the command “G50 T 3C 90” is
The group number of tcol
to be selected by
“T 01 * ~k” command.
The group number of tool
to be selected by
“T 02 * *” command.
executed in the following programs, the
control operates as shown in the table
ti8602
below.
Tool groups are
“1 to 19.”
The tool whose
life has expired
has a minus
value.
Program for Tool Information Registration
\
\
The group number of tcol
to be selected by
“T 50 * *” command.
o
. . .
G122 ;
P1 L1OO ;
TO1O1 ;
T0303 ;
T0606 ;
‘1” ‘“””
G123 ;
M30 ;
$8650
* * indicates compensation number,
b. Registration of life of each tool group
Table 2.28
Contents
Remarks
Setting
No.
Part Program
I The life of group number I
“l.” (The number of
machinable pieces)
The setting range
of the number of
machinable pieces
is 1 to 9999
(units),
I
T0190 ;
G~O T0190 ;
-1-1 –u+
L(
J
I
n6169
The life of group number ~
“9.”(The number of
machinable pieces)
The life of group number
“1O.” (Machinable hours)
\
Tool no, of
I
Operation
GrouD no. 01
by “G 50 T 0190
!
01 “G50 T5100 .
$6170
03 I “G50 T 5300’
The setting range
of the number of
machinable hours
is 1 to 9999
(minutes).
C6
“G 50 T 5600
Tool life control and setting
The registration of tool information and the
monitoring of the currently used tools are
z
performed using the setting area. Shown
below is the list of settings used for tool
life control.
c.
—
131