2.8,30. lTaper Multiple Cornering (Gill) (Cent’d)
Table 2.35 Directions of Second Beveling
Table 2.36 Direction of Second Runding
(Cent’d)
(Cent’d)
B command
value for sec-
ond straight Iine
move angle
B command
value for sec-
ond straight line
move angle
Beveling
.x
direction
i
Rounding +x
direction
L
}Z
Other
conditions
Other conditions
+-z
Beveling in X, Z posi-
tive direction
)
Rounding in X, Z posi-
tive direction
180.000< B,
B < 270.OCO
–18CI.000 < B,
B < –90.000
Second straight
line is specified
with B, Z (W).
CI<B,
B <90.000
–360.000 c B,
B < –270.OCKl
Bevelig in X, Z nega-
tive direction
Rounding touching the
straight line parallel to
X-~is
First straight line
moves in Z nega-
tive direction.
)
.-
Second straight
line is specified
with B, X (U).
B = 270.OCO
—
—
–90.000 Beveling in X negative,
Z positive direction
Rounding touching the
straight iine parallel to
Z-wis
First straight line
moves in Z pa3i -
tive direction
z (w)
command
may not be
used.
Rounding in X, Z
First
positive direction
straight
line moves
..-
r
in Z-axis
Beveling in X negative,
Z positive directjon
J
positive
direction.
/
/’
270.OCO < B,
B <360,000
–90.000 < B,
6<0
B = 90.000
—
—
–270.000
Rounding in X
positive, Z nega-
tive direction
First
straight
Iine moves
in Z-axis
negative
direction.
---
(
Table 2.36 Directions of Second Rounding
Rounding
direction
-x
L
-z
Rounding in X positive,
Z negative direction
B command
value for sec-
ond straight Iine
move angle
Other
conditions
Second straight
line is specified
with B, X (U).
x (u)
command
may not
be used.
90.000< B,
B <180.000
–270.OCO < B,
B < –180.000
Rounding touching the
straight line parallel to
z als
Rounding in X
negative, Z posi -
tive direction
~.----
First
straight
Iine moves
in X-axis
negative
direction
Second straight
line is spwified
with B, Z (W).
6=0
= 360.000
—
—
–360.000
Rounding touching the
straight Iine parallel to
X axis
Rounding in X, Z
positive, direction
First
straight
line moves
in X-axis
positive
direction
7--”-
To Next Page
Loading...
