YASKAWA yasnac lx3

4.a
(4)
a.
b.
c.
d.
e.
d.4 Haaress bearcn i~ontctj
Search of program number
The address search function also permits to
search a part program out of those stored in
the memory.
Select MEM or EDIT mode.
Depress the PROG function key.
Depress the RESET key.
Enter the program number 1’0 ~ D c
❑ . “
Leading zero can be
omitted.
Depress the
m key.
1
.,
The designated program number will be
searched. The result of search is as de–
scribed in ( 2). In MEM mode, you may de–
press the CYCLE START button immediate y
after completion of search to start automatic
operation from the beginning of the program.
4. 3.4 CURRENT POSITION DISPLAY
‘rhe current position of X-, or z -axis can be dis-
played at any time in all modes. Operating pro-
cedure is as follows.
(1) Depress POS key.
One of the. following will be displayed on the
CRT screen.
a.
b.
c.
d.
e.
f.
g.
h,
i.
(2)
POSITION EXTERNAL
POSITION ABSOLUTE
POSITION INCREMENT
POSITION
PROGRAM RETURN
DISTANCE TO LIMIT
PULSE COUNTER
ERROR PULSE
COMMAND PULSE
Depress
--PAGE
PAGE
keys to
select
the page including any of the above .
Note :
Page including error pulse or command
pulse willse displaye~ when SYSTEM No. switch
is set at 4.
4.3.4.1
Position [EXTERNAL]
(1) The current value to be displayed in EXTER-
NAL is the accumulated value of the tool
movement from the position reset to “ Oil by
the ORG key.
(2) HOW to
reset POSITION [EXTERNAL]
Display the POSITION [EXTERNAL] screen
on the CRT , select the axis by the address
key, and depress the ORG key. The dis-
play of the selected axis becomes “O.“ This
display reset operation is always valid
even during time when the movement is being
made by the automatic run of part program .
Notes :
1,
2.
3.
4.
When parameter POSEXT ( #6005D5) is set to
“ 1, “ the value displayed in POSITION
EX-
TERNAL becomes the same value as dis–
played in POSITION
ABSOLUTE .
Regardless of the state of parameter POSEXT ,
the value displayed in the external current
value display (option) is the same as display-
ed in POSITION [EXTERNAL] . Hence, reset-
ting the external current value display auto–
matically causes the reset of POSITION
EX-
TERNAL .
The “value in the current value display of
the equipment”
described in 2.8.22, Work
Coordinate Multi-Shift G50T and 5.2,3,
Measured Workpiece Value Direct Input
refers to this value in POSITION
EXTERNAL.
The display lock feature is valid for POSI-
TION [ EXTERNAL].
162