YASKAWA yasnac lx3 - Page 169

Up to 10 lines may be displayed at a time.
When execution of the ninth has been com-
pleted, the next page appears with the
tenth line of the last screen appearing at
the top.
4.3.3, 3 Display in EDIT Mode
See 4.6 EDIT.
4. 3.3.4 Address Search
Search continues until a data (character string)
held on tape or in the memory which coincides
with the data (character string) entered through
the NC operator’s station.
The contents
of tape willbe searched in TAPE mode and those
of the part program memory in MEM or EDIT mode.
(1)
a.
b.
c,
d.
operation (MEM, EDIT mode)
Select MEM, or EDIT mode.
Depress the PROG function key.
Depress the RESET key. “LSK” appears
and the pointer returns to the top of the
program number in MEM mode.
Search is performed in one of the following
three methods:
(i)
(ii)
(iii)
Key-in the word (an address data) to be
searched. If the leading zero of the data
is omitted, the search operation is still
possible.
Key-in only a single character without
data.
This permits searching the charac-
ter read first.
Depress the NEXT key then key in any
data (less than 32 characters) to be
searched.
In this case, the search oper-
ation is performed exactly according to
the keyed data (character string or nu–
meral string), thus disabling the omission
of leading zero.
e.
f.
.—
CURSOR
Depress the .
key.
Search
starts.
“AS” blinks during search.
When the NEXT key is depressed, depqess
it again to cancel the pattern search func–
tion
(2) Completion of search
a.
When the search is completed, “AS” will
disappear.
(i) In MEM or EDIT mode, the pointer of the
part program memory points to the data
of block found (indicated by the cursor) .
In all cases, only search will be per-
formed but neither BUF display nor ad-
vance reading will be performed.
b
(3)
a.
b
~.
MEMORY
POINTER
t
DATA FOUND
“AS” disappears and “NOT FOUND !“ appears
on the CRT if the desired data is not found.
This message willdisappear when you de-
press a key (CAN normally) of the control
station.
Remarks
Commands encountered during search will
be ignored even if they are modal commands.
On Cycle Start after search, the data of a
block which the pointer points to willbe
read in and executed.
161