YASKAWA yasnac lx3 - Page 184

4. 4.1 LOADING PART PROGRAM TAPE INTO MEMORY
(Cent’d)
c.
Set the NC tape to the tape reader or the
external equivalent equipment.
\
%,01234 G50, XOY0
M30
?(O
)
I
PROGHAM NuMBE7
1
HOLD HERE
d.
e.
f.
Depress the RESET key.
Key in “O” and PROGRAM NUMBER.
Depress the IN key.
The program number entered from the key
is registered in preference to the program
number punched on the tape. At this time,
the program number on the tape is written
to the part program memory simply as a
label.
M02 ;, M30
; or M99 ; is read and the stor–
ing operation is completed.
Note :
If a program is stored with a changed
program number as described above, the program
number punched on the tape is stored in the part
program memory without change,
Consequently,
to avoid the confusion in the later handling, re–
place the program number in the part program
memory with changed program number by the
EDIT operation.
(4)
a.
b.
c.
Loading part programs from a tape
Select EDIT mode.
Depress the PROG key.
Load the NC tape to the tape reader or an
equivalent exte-rnal device ~
$
“1.,01000, M02 0200
M30,0500 M99,O/.
\
, 1 I
d.
e.
!
I 1
The tape slops
T1e .aoe stops The tape stops
to Iravel here
to t,a.e here
to travel here
Depress the RESET key.
Depress the IN key.
Then the system starts to read the tape
and enlists the program number punched
on the tape as the first record.
The sys-
tem checks for duplication of program num-
ber as described in (2) .
f
(5)
The tape reader stops each time it has read
“M02 ;,” “M30 ;,“ or “M99 ;.”
Depress the IN key again.
The tape reader resumes to read the tape,
Repeat this operation until allprograms
are loaded.
Storing a program with program numbers
(6)
changed II
When “O” key is depressed and program
number is keyed in before depressing IN key
as described in (4) above,
the keyed in pro-
gram number is registered in preference to
the program number punched on the NC tape
Loading programs continuously
l?rograms existing on a tape as shown in (4)
may be loaded continuously without inter–
ruption. For this purpose, depress “O, “
I,_ ,, ,,9, ,, ,19, ,, ,Ig,ll
and “ 9“ before the first
depression of the IN key. The tape reader
stops at the position of “%. “
4. 4.2 MAKING ADDITION TO A PART PROGRAM
Perform the followine oDeration to add data to a
part program which ~s &eady loaded.
a.
b.
c.
Select EDIT mode.
Depress the PRGG key
Depress the O key then enter the part pro–
gram number and depress the
C[’KSOI{
key.
The system searches the designated program
Load the tape of adding data to the tape
reader.
d.
(
e.
Depress the RESET key.
f. “Depress the NEXT and IN keys in this
order.
The data will be read from the tape into the
memory.
Notes :
1.
You
cannot add data to the middle of a pro-
gram.
If necessary, delete the last part of the
program by editing operation and add the data.
2.
Continuous storing operation of NEXT and
IN needs reset key operation every time.
176