YASKAWA yasnac lx3

4. 4.5 INPUTTING SETTING DATA AND PARAMETER
DATA
Through setting data and parameter data are in-
put in their memories by MDI operation normally,
they may also be entered by means of paper tape,
Setting data and parameter data may be input
from
(1)
(2)
a.
b.
c.
d.
e.
f.
g.
a single tape.
The tape format is as follows.
—
r
“~
LABEL % ;
N6000 X128;
I
I
N6002 X O;
N8750 X O;
%
-. J
The input operation is as follows ~
Set the SYSTEM No. switch at 1.
Select EDIT mode.
Depress the PRM key.
Depress the RESET key.
Depress IN key.
The tape reader starts to read the tape.
“IN” blinks on the CRT while the data are
being read.
The tape reader stops when it has read “ %“
(or “ER”) .
!!lN!!
disappears from the CRT .
Now the setting lparameter data have been
read into memory.
Return the system No. switch to O.
Turn the power off then on.
The NC operation by the newly stored set-
ting data and parameter may be performed.
Note: At the end of operation e. , the op–
erations on the NC operat~]r’s panel are all
invalidated.
Hence,
the power must be
turned on again.
4.5 TAPE VERIFYING
The punched tape of the data shown below may
be compared to the contents of the NC internal
memory to check if they match.
~ Part program
. Tool offset data
. Setting data and parameter
The punched tape is entered through the NC
tape reader or the data input/output interface
(option). For the methods of setting the input /
output equipment (setting #6003) and the baud
rate (parameters #6o26 through #6029), refer to
“YASNAC1LX3 Maintenance Manual. “ The
following description is made assuming that this
option
4. 5.1
(1)
a.
b.
c.
d.
e.
(2)
a.
b.
c.
d.
e+
is installed .
VERIFYING PART PROGRAM TAPE
Verifying a part program tape having pro-
gram number
Select the EDIT mode.
Depress the PROG function key.
Set the part program tape to the tape reader.
Depress the RESET key.
Depress the VER key.
The tape is
started to compare the con–
tents of the part program memory to the
contents of the part program tape.
During
this operation,
IIVER )! keeps flashing. If
a mismatch is found , “INPUT ERROR” is
displayed flashing .
When a match is found and this operation is
completed, the tape reader stops, upon
which “VER” display is erased.
Note:
By the operation of “RESET , VER, “
the verifying feature verifies the data from
the tape head to % code.
Verifying a part program tape having no
program number
Select the EDIT mode.
Depress the PROG function key.
Set the part program to the tape reader
Depress the RESET key.
Depress the “()” key an[{ key in program
number.
178