YASKAWA yasnac lx3 - Page 187

f.
Depress VER key.
The tape starts to compare the contents of
the part program memory to the contents of
the part program tape.
During this opera-
tion,
!!VERI!keeps flashing.
If a mismatch is
found,
lllNpUT ERORII is displayed flashing.
When a match is found and this operation is
completed, the tape reader stops, upon which
!!VER!! display is erased.
If the keyed-in
program number is not found in the memory,
!!NOT FOUND! u is displayed flashing.
In this
case, depress the CAN key and start with the
operation of d.
Notes :
1.
2,
(3)
a.
b.
c.
d.
e.
The operations for verification with a pro-
gram number different from the program num-
ber punched on the tape are the same as those
of (2) above. The keyed–in program number
is processed in preference to the punched
program number
Verification by the operation of “OXXXX VEf7°
regards the punched information as the in–
formation on the keyed-in program number.
Hence . when verifying a tape containing
program numbers, no program number should
be keyed in.
Verifying a tape containing multiple part
programs
Multiple part programs punched in a single
tape are continuously verified by the follow-
ing operations:
Select the EDIT mode.
Depress the
Set the part
er.
Depress the
Depress the
PROG function key.
program tape to the tape read-
RESET key.
VEX key.
When M02, M30, or M99 is read, the tape
reader does not stop but all the part pro–
grams are continuously verified up to %
code. When the verification is completed,
the tape reader stops at the position of %
code.
4. 5.2 VERIFYING TOOL OFFSET VALUE TAPE
The contents of the tool offset value tape are
compared to the contents of the offset memory
by the following operations:
( 1) Select the EDIT mode.
(2) Depress the OFS function
key.
(3) Set the
tool offset value tape to the tape
reader.
(4) Depress the RESET key.
(5) Depress the VER key.
The tape starts to compare the contents of
the tape to the contents of the tool offset
memory .
During this operation , “VER”
keeps flashing. If a mismatch is found,
“INPUT ERROR” is displayed flashing.
When a match is found and this operation is
completed, the tape reader stops, upon
which ‘IVER” display is erased.
4. 5.3 VERIFYING SETTING AND PARAMETER TAPES
The setting data tape or the parameter tape is
compared to the respective contents of the mem-
ory. It is possible to punch the setting data
and parameter on a single tape and store them at
a time by the following operations:
(1)
(2)
(3)
(4)
(5)
Select the EDIT mode.
Depress the PRM function key.
For the tape punched only with setting
data,
depressing the SET key causes the same
effect.
Set the setting data and /or parameter
tape
to the tape
reader.
Depress the RESET key.
Depress the VER key.
The tape starts to compare the con–
tents of the tape of the contents of setting
or parameter.
During this operation, “VER”
keeps flashing.
If a mismatch is found,
“INPUT ERROR” is displayed flashing.
When a match is found and this operations is
completed, the tape reader stops, upon
which “VER” display is erased.
1 7s