(4) Repeat the operations of (1) through (3) to
modify any number of words .
PROGRAM (EDIT)
00003 NOO03
I
03;
N1 G50 X1OO. ZIOO. ;
i
N2 GOO TO1O1;
N3 G96 S150 M03;
N4 X20.3 21.5;
N5 20.5:
N6 z-10.5 F5;
11
G01Z0,5F20
1
*Keylin
8
After insertion
PROGRAM (EDIT)
00003 NOO03
I
I
L
03;
I
N1 050 X1OO, Z1OO,;
N2 GOO TO1O1;
N3 G96 S150 M03;
~5 GO1 ZO.5 F20;
N6 Z-10.5 F5;
4. 6.4 ADDING PART PROGRAMS
A part program is added in the EDIT mode and
the PROG function by the operations shown below
which follow the operations of 4. 6.2 Displaying
And Checking Stored Part Programs.
(1)
(2)
(3)
(4)
I
IS K
RDY
~.
Fig. 4.47
Depress the page key and the cursor key to
designate the word immediately before the
portion to be added.
Depress the address key and data key to
key in the word to be added. Within the
limit of 32 characters, the data may extend
over multiple words or blocks.
Depress the INSRT key.
The keyed-in data is added to the portion
immediately after the word designated by
the cursor. After the addition, the added
word is in the designated state.
Repeat the operations of (1) through (3)
to ~dd any n-umber of words.
L1
—
I
After !nsertlon
Fig. 4.48
181
To Next Page
Loading...
