5.1.30 POSITION STORE PUSHBU~ON +
This button switch is for directly inputting mea-
sured workpiece values.
When this button is pushed, the current tool
values (position or external display values) are
stored temporarily in the register ,the MEASURED
WORKPIECE VALUE DIRECT INPUT mode is turn-
ed on, and the LED of the OF S function key
flickers. At the same time, the CRT displays
the tool offset value diagram.
For detailed procedure, refer to 5.2.3,“ Mea-
sured Workpiece Value Direct Inputt .“
5.1.31
FS AUTOMATIC EDITING FUNCTION
5.1 .31.1 General
The effective values of the feedrate and spindle
speed during automatic operation are stored and
feed back to the NC part program to create the
optimized program.
The feedrate (F code) and
spindle speed (S code) will hereafter be referred
to as FS.
5.1.31.2 Input/Output
The following 1/0 signals are required for the FS
editing.
5.1.31.2.1 Input
(1)
(2)
(3)
(4)
FSCM (#13134) . . . FS editing mode
Close this signal for FS editing, to prepare to
store the FS and change the FS memory.
FSMEM (#13135) . . . FS storage
Close this signal during automatic operation,
to call up the operating feedrate or spindle
speed data into the internal memory.
FSCH (#13136) . . .
FS memory change
Close this signal while holding automatic
operation,
to reflect the data called up during
automatic operation in the NC part program.
FSCLR (#13126)
. . . FS data clear
Close this signal to clear the stored FS data.
5.1,31.2.2 Output
(1) FSMD (#12183) ...
During FS editing mode
This signal indicates that FSCM is closed, and
it is ready for FS storage and FS memory
editing.
When this signal is switched from “closed” to
“open” , the feeclrateand spindle speed data
are canceled.
(2)
(3)
FSCE (#12184) . . . End of FS memory
alteration
This signal closes when the FSCH closes and
the data are reflected in the NC part
program,
and opens ag~in when the FSCH
opens.
FSCLRE (#12233) ... End of FS data clear
This signal closes when the FSCLR closes and
the stored FS data are cleared, and opens
again when the FSCLR opens.
5.1.31.3 Functions
Rough FS data can be programmed in the NC part
program, to allow optimization of the feed override
and spindle override after actual cutting.
The optimization data and position in the actual
cutting program can be stored in the internal
memory of the NC, and reflected in the part
program by closing the FS memory alteration
input.
5.1.31.4
Operation Procedure
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Be
ready for operation.
Search the operation program under the
memory mode.
Close FSCM.
Check that FSMD is output, and start the
memory operation .
Change the feedrate and spindle speed for
optimization,
Close FSMEM when the optimization is
completed.
Repeat (5), (6) in sequence.
Hold the operation (label skip) .
Close
FSCH. , . .
(10) Open FSCH. . . .
(11) Open FSCM. . . .
The execution value stored
by FSMEM is stored in the
part program.
FSCE opens.
The data stored in (5), (6)
is canceled.
196
To Next Page
Loading...
