6. OPERATION PROCEDURE
6.1 INSPECTION BEFORE TURNING ON POWER
Make sure that the front and rear doors of the
control are firmly closed. The control employs a
totally-enclosed, dustproof enclosure to shut out
surrounding air.
If the door is open, lock it by
turning two door locks. In addition, inspect the
machme referring to the machine tool builder’s
manual.
6.2
(1)
(2)
(3)
(4)
‘TURNING ON POWER
Check to see that the main power is supplied
for the control.
Depress the POWER ON pushbutton on the
operator’s panel ~
and the control power is
supplied and then the cooling fans will start
running.
Make sure that air blows out from
the exhaust ports” of the upper side of the
control.
Depress the POWER ON pushbutton again to
turn on the servo power supply. When the
machine is ready to op~rate, READY lamp
lights .
If READY lamp does not light, detect and
eliminate the cause according to the alarm
code displayed.
Refer to 4. 3.9 DISPLAY-
ING ALARM CODE.
6.3 MANUAL OPERATION1
When the MODE SELECT switch on the machine
control station is set to RAPID, JOG, STEP
or HANDLE position, the machine can be oper-
ated manually.
Operation in RAPID Mode
(1) Set MODE SELECT switch to RAPID.
(2) Select the speed using RAPID TRAVERSE
RATE OVERRIDE switch.
Speed setting range: 100% - 50% - 25% - FO
(3) Push JOG button to select the axis and
direction of movement. The
machine moves
at the specified speed while the JOG button
kept pressed.
1 Manual operation is defined as the operation
in RAPID, JOG, STEP, or HANDLE.
Operations in JOG Mode
(1) Set MODE SELECT switch to JOG.
(2) Adjust the feedrate to the desired setting
with JOG FEEDRATE switch (Up to 32 steps) .
(3) Push JOG button to select the axis and direc-
tion of movement.
The machine moves at the
specified speed while the JOG button de–
pressed.
Operation in STEP Mode
(1)
(2)
(3)
Set MODE SELECT switch to STEP.
Select the move amount per step using
MANUAL PULSE MULTIPLY switch.
(Move amount setting range)
Metric:
~.ool-o. ol-o.l - 1.0- lo.o-
100.0 mm/step
Inch:
0.0001- 0.001- 0.01- 0.1- l.o-
10.0 in/step
Depress JOG button to select the axis and
direction of movement. The machine moves
by the move amount per step each time the
button is depressed.
213
To Next Page
Loading...
