YASKAWA yasnac lx3 - Page 230

APPENDIX 1 LIST OF SETTING NUMBERS (Cent’d)
,... -——
;
I
~6206 ~
G 76
OFL
G763FL :
Sets; cut
depth (in X-axis) “a” in Automatic
l“hreadcutting (G76) ,
Setting range: O - 65536
Setting :
Least input increment
:6207
TINON
When the tape without program no. is stored,
program no.
is set for the tape.
$6219
~r SNSW
—
—––— L-
Setting:
O, 1, or 4 of system No. switch
“o”: SYSTEM
For usual operation. Writing parameters is
pre\,ented.
!!lll:
PARAMETER
To write parameters.
At this position, the
Cyc.e Start is prevented.
“4” : TEST (0)
The usual operation is similar to case of “ O“
SYSTEM .
Self-diagnostics of the memory
contents and checking of reference zero
return point are omitted.
Notes :
1. Setting the values other than described above
cannot permit the correct operation.
2. Setting can be effective only when the system
number switch provided on the upper part of
the unit is set at 11O.‘1
:6501
XSL2P, ZSL2P:
Sets the boundary area
Stored Stroke Limit secor
ZSL 2 P
n positive direction of
d prohibit area on X-
axis and Z–axis, respectively.
Setting range:
O to ?99999999
Setting : Least output increment
A--4
r ‘-
v6502
XSL 2 M
i -–— _— ._
J16503
~-
1----J
ZSL 2 M
XSL2M, ZSL2M:
Sets the boundary area in minus direction of
Stored Stroke Limit second prohibit area on X-
axis and Z–axis, respectively.
Setting range:
o to f99999999
Setting: Least output increment
36504 i
~ [___ zSL3 P
I
26505
: ,---
1 .-
ZSL 3 P
XSL3P, ZSL3P:
Sets the boundary area in positive direction of
Stored Stroke Limit third prohibit area on
X–axis
and Z–axis, respectively.
Setting range: O to *99999999
Setting: Least output increment
~——
?6506
IL
XSL3M
T
,–-–-: :::- “-v_ ::___ ‘“--:_ ‘—
;6507
ZSL 3 M
—1 L_– ____ _-
XSL3M, ZSL3M:
Sets the boundary area in minus direction of
Stored Stroke Limit third prohibit area on X-axis
and Z–axis, respectively.
Setting range: O to *99999999
Setting:
Least output increment
,—
x651 1
.—
,—————
–1
x6512
s6513
:6514
=6515
s6516 ;
T 3 XSLP