YASKAWA yasnac lx3 - Page 241

= r:
XPERML
““--”-T
IF~ F
ZPERML
7
XPERML, ZPERML:
Sets leadscrew error compensation multiplication
factor for X- and Z-axis.
Outputs the result of the preset compensation
value multiplied by the multiplication factor as
the error compensation value.
Setting range: O - 255
XPSET
I
r—
I
#6057 I
ZPSET
I
SPSET
I
I
#6058 I
——
XPSET , ZPSET , SPSET :
Sets position error range
spindle (at indexing) .
Setting range: O - 255
for X-, Z-axis and
(Setting O
will not execute compensation. )
~
XSVER
I
L
ZSVER
r
SSVER
!
I
Setting: Least output increment
I
BSX
I
~——–.——.—
——~
I #6063 I
I
BS Z
I
1..-~
,—.—.—
1
r————- —
BSS
I
XSVER, ZSVER, SSVER:
Sets servo error limit for X-, Z-axis, and
spindle. Position deviation exceeding the preset
value activates an alarm ‘134A. 11
Setting range: O - 255
Standard setting: 16
Setting:
1/16 x (D/A saturation value)
1—–——. .1
Bsx, Bsz, BSS:
Sets D/A conversion bit for X-, Z-axis, and
spindle (at indexing 1.
#6062
Bit ~
Max No. of
#6063
Error Pulses
#6064
ZiE!zlr
CUPRD
4
---1-----
12 bit 2047
5
13 bit 4095
Rapid threading pull-out width during thread-
cutting
Setting range: O - 255
Setting: O. 1 lead
E’1
SIDSER
Spindle stop check timer at spindle index start.
Setting range:
O - 225
Setting: l=8ms
6 I
14 bit 8191
7 I 15 bit
16383
8
I 16 bit
32765
Max No. of
Max
Feedrate (pulse/s)
Error Pulses =
Position Loop Gain (l/s)
Setting range: O - 255
Setting:
Least output increment