APPENDIX 2 LIST OF PARAMErER NUMBERS (Cent’d)
.——
#6225 i
r
KPX
“7
‘..~ L
—––- —
.
#6226 I KPZ
<’
~–_
-.I
KPX, KPZ:
Set the P-loop gain of command units for X- and
Z-axis respectively.
Setting:
Standard set:
1024
KPS :
Set the P-loop gain of spindle at indexing.
‘The relations between KPS and BSS (#6064) as
fo]lows :
Max. Set
#8084 i
I
No. of Bit
No. of Max.
Of # 6227
offset pulse
4096 4 12
2047
2048
5
13
4095
1024
6 14
8191
512
7 15
16383
256 8 16
32765
[ --;= ~
G 98 MAX
.—
.=
G98MAX :
Specifies the maximum feedrate at G 98 command
( feed per minute) common to all axes.
Setting range:
Setting:
“ 1“ = 1000 puLses/min
NEGNR :
When a circular path is drawn in Tool Radius Com-
pensation o,utside a corner approaching 180°, the
movement follows describing a very small circular
arc.
This parameter is used to set the critical
arc value, if this arc movement is considered to
affect the workpiece surface machining.
Setting range: O - 65536
Setting :
Least input increment
The corner arc setting is
AX S NEGNR
AY S NEGNR
Standard setting = 5
AZ
ignored when:
; ➤ ✍ ✍✿✿✿
‘623’I L..— ._..!!!vF~.. ----
ROVFO :
Specifies the FO speed for Rapid Traverse
Override.
Setting range:
Setting :
“ I“ = 125 pulses/see
Ea [:-: ‘=- ‘---–-::
G31F:
Specifies the feedrate in the skip function ( G31) .
Setting range:
Setting:
III!! = 1000 pulses/rein
This setting is effective when parameter #6019D 4
(SKPFED) = 1.
3 E-”=G~---–”--
I
\-
~q ~
—-’–-—–-”-”,
~
JOG 31
___
JOG O-JOG 31:
Specify the feedrates for the respective positions
on the jog feedrate select switch.
Setting range:
Setting:
!!l!!= ().5 mm /rein(metric OUtpUt)
Ill!!= 0.05 im/min (inch output)
A--18
To Next Page
Loading...
