YASKAWA yasnac lx3 - Page 248

APPENDIX 2 LIST OF PARAM=ER NUMBERS (Ccmt’d)
Set 2nd step constant for linear accelldecel of
X–
i~nd Z–axis, respectively.
Setting:
111!! = 125/8 X 103 p/S2
Note :
Parameter setting for linear 2nd step
accel/decel must be set under the following
conditions:
c2nd step accel/
1[
Rapid accel/
decel change speed
1
= decel constant x N
.#6318/#6319
J
#6286 /#6287 J
If the above conditions are not satisfied,
the positioning may not perform correctly,
zfi323 !
ZPERED
XPERED, ZPERED:
Specify the
number of the end point for Leadscrew
Error Compensation,
respectively, on the X- and
Z-axes.
Setting range: O - 255
XPERED, ZPERED:
Spec:ifythe number of the start point for Lead-
screw Error Compensation, respectively, on X–
and Z–axes.
Sett:.ng range: O - 255
Specify the reference point for Leadscrew Error
compensation, respectively, on the X– and Z-
a.xes.
Setting range: O - 255
Sets the spindle speed for spindle indexing.
Setting range :
0 - 32767
Setting:
1 = 500 pulse per second
Sets the spindle indexing creep speed.
Setting range:
O - 32767
Setting :
t!ltl = 5(IO pulse per second
# 6347
BSBON X (X-AXIS)
—
$6348
BSBON Y (Y-AXIS)
Setting time from ESP to SVOFF in X-AXIS and
Z-AXIS in order:
“1“ = 8 ms (unit)
O - 32767 (setting unit)
= 6349
L
‘- EmT;p :—-–-:
HINTPP:
Set
the handle interpolation reference pulse count.
Setting range: O - 65535
–m= ., ~_. —. ..— -—- ____ _
XSL 1 P
.—
-“”; ~--
T6601
ZSL1 P
L ___ .._ ____
XSLIP, ZSLIP:
Specify the plus direction boundary value for
Stored Stroke Limit 1, respectively, on the X-,
and Z–axes.
Setting range : 0 - 99999999
Setting:
“ 1“ = 1
pulse
Sets the reference point for spindle indexing.
Setting range: O - 4095
Setting:
“1“ = 1 pulse (= 360/4096 deg. )
A–22