YASKAWA yasnac lx3 - Page 250

–—
:z6626
MA XDUW:
Sets upper
APPENDIX 2 UST
~. —-—- -— __
,
MAXDUW
.—— —
limit of U and W for offset data.
Of PARAMETER NUMBERS (Cent’d)
The
input of the value exceeding the limitwillcause
an alarm.
Note:
Parameter #6018 D3 is set to “1 , “ the pa-
rameter setting is effective.
,—
~6630 ~
XSETI
I
,—
..—
T16631 {
~
ZSETI
I
- ..J L—..
–—J
XSETI, ZSETI:
Specify the value for Automatic Coordinate
System Setting at the time of inch input, respec-
tively, on the X-, and Z-axes. A desired value
should be set in inches for the distance between
the first reference point and the reference point
of the coordinate system to be established.
Setting range:
-99999999- 99999999
Setting:
“l” = 0.0001 in.
—.
f16636 ~ ~
XSETM
—1 ;T:::T-”--”—-- --- — -.—. ~
a6637 ‘
.4 L___
ZSETM
XSETM , ZSETM :
Specify the value for Automatic Coordinate
System Setting at the time of metric input, re-
spectively,
on the X-, and Z–axes,
A desired
value should be set in millimeters for the dis-
tance between the first reference point and the
reference point of the coordinate system to be
established.
Setting range:
-99999999- 99999999
Setting : “1” = 0.001 mm
~.—–
—-1
; 6642
XPEINT
!
-]
I
1
,w3643 ;
ZPEINT
~i
—,
XPEINT , ZPEINT :
Specify the compensation inverval in Leadscrew
Errc, r Compensation, respectively, on the X- and
Z-axes .
Setting range: -99999999- 99999999
Setting:
“l” = 1 pulse
HSDM1:
Set the high–speed M function decode output set
1.
L= [._-c ... XDX..-. _
HSDM2:
Set the high-speed M function decode output set
2.
(
—-
Lu!f-1L—
HSDM3:
Set the high-speed
1.
!
! # 6647
-d !.—
HSDM4:
Set the high-speed
2.
HSDM 3
—
M function decode output reset
HSDM4
M function decode output reset
T
EEEEcl~“’ . ~
DIVERR:
Set the instruction point value code segment value
for division error.
*8000
I
- r“”- ‘::”.
PEMN O
A _— _
\
-— —— .7
z8255
PEMN 255
I
—
— -J1 L — -— -—- —. —- --- -—
PEMNO-PEMN255:
Specify the respective values of Leadscrew
Error Compensation.
Setting range:
O - 315 (Incremental designation)
O - f128 (Absolute designation)
Setting:
“ 1“ = Output increment
Incremental /absolute designation is selected by
parameter #6023D7 (pERIAB) .
Axis for compensation is specified by parameters
#6322, 6323, 6328, and 6329.
A–,24