YASKAWA yasnac lx3

Code
Causes
I Code
Causes
048
PROG ERROR (G41-44)
I
060 PROG ERROR (G34)
INTERSECTION PO IN TN OT OBTAINED BY iNTER-
SECTION COMPUTATION.
049
PROG ERROR (G41-44)
LEAD lNCREASE/DECREASE VALUE EXCEEDING
MAXIMUM PROGRAMMABLE VALUE DURING -
VARIABLE LEA D THREAD CUTTING,
MI NUSVALU EOF LEAD COMMANDED.
061 PROG ERROR (Gil/G12 IN THREAD)
REVERSE OR ALMOST REVERSE COMMANDED IN
M97 MODE.
I
ROUND IN G, BEVELING COMMANDED IN THREAD
CUTTING BLOCK.
—
050
PROG ERROR (Gil/12)
1, K, R NOT CORRECTLY COMMANDED FOR BEVE-
LING AND ROUNDING. VALUES OF 1, K, RTOO
LARGE.
062
PROG ERROR (G32/G33}
THREAD CUTTING COMMANDED IN G98 MODE.
MU LTI-START THREAD CUTTING COMMAND B
OUT OF SPECIFIED RANGE.
051
PROG ERROR iGlll12)
1
063 PROG ERROR (G92/’G78/G2l)
RAP ID THREAD PULL-UP VALUE IN X-AXIS
TAPERING COMMAND IN BLOCKS FOR BEVELING
AND ROUNDING.
DIRECTION IN THREAD CUTTING WITH BEVELING
SMALLER THAN BEVELING VALUE SET BY
PARAMETER.
052
PROG ERROR (GO1)
I 064
PROG ERROP (G92/G781G21)
ANGLE PROGRAMMING NOT CORRECT DURING RARID THREAD PULL-UP VALUE IN Z-AXIS
ANGLE PROGRAMMING LINEAR IN TERPOLAT!ON DIRECTION IN THREAD CUTTING WITH BEVELING
BY GO1. VA LUESET BY PARAMETER.
053
PROG ERROR (G50T/G92T)
VALUES OF TOOL COORDINATE MEMORY OUT OF
THE RANGE BETWEEN 51 T0801N WORK Coordi-
nate SYSTEM SETTING BY G7JOT
054 G51 POS-EXT ERROR
COMMAND VALUE (EXTERNAL VALUE)
TO RETURN AT G51 EXECUTION
TIME IS WRONG.
065
I
066 CA NNOT CO NT IN UOUS THREAD
TOO SHORT TIME FOR 1 BLOCK OF
CO NT IN UOUS THREAD Cutting.
055
?ROG ERROR (M, S,T)
\ 067
!
M, S, TCOMMANDS IN THE BLOCK IN WHICH M, S, 068
T CODE CANNOT BE COMMANDED.
--L-——–—
056 PROG ERROR (AXIS)
I 06f3
PROG ERROR (G151 DATA)
!
AXIS COMMAND IN G20, G21 BLOCKS. AXIS-NOT
1
ERROR IS FOUND IN THE G151 COMMAND DATA
CORRECTLY COMMANDED IN G04, G36-G38.
057
+
058
MIRROR IMAGE
G28 IS COMMANDED
DURING
MIRROR IMAGE MODE
070 PROG ERROR (M02/’M3O/M99)
MEMORY OPERATION COMPLETION COMMAND
NOT GIVEN.
071
G151 ERROR
G151 COMMAND ERROR
059
ZR UNREADY
I
072 PROG ERROR (G50TIG50XZ)
G28NOT COMPLETED ON THE AXIS WHICH HAS
G50TOR G50XZ IS COMMANDED WHEN THE
G29 COMMANDER REFERENCE POINT RETURN
COORDINATE SYSTEM IS SE TBY THE TCODE.
NOT CO MPLETEDON THE AXIS WHICH HASG30
COMMAND.
G68 IS COMMANDED BY MIRROR IMAGE
GRADE UP SPECIFICATIONS (46019D1 = 1).