YASKAWA yasnac lx3

APPENDIX 5 LIST OF ALARM CODES {Cent’d)
Code
073
074
075
076
077
Causes
RS232C ERROR (OVER-RUN)
10 CHARACTERS MORE HAVE BEEN READ IN
AFTER STOP CODE HAS BEEN TRANSMITTED
THROUGH RS232C INTERFACE
078
079
080
TOO LSETCMP ERROR
TCODE COMMANDED BEFORE G35 BLOCK. G98
COMMANDED IN OR BEFORE G35 BLOCK.
081
TOO LSETCMP ERROR
ERROR OF PARAMETER SETTING FOR TOOL SET
ERROR COMPENSATION (X)
082
TOOL SET CMP ERROR
ERROR OF PARAMETER SETTING FOR TOOL SET
ERROR COMPENSATION (Z).
083
TOOL WEAR CMP ERROR
COMPENSATION NO. EXCEPTO1 TO 19 DESIGNATE
AT TOOL WEAR COMPENSATION
084 TOOL WEAR CMP ERROR
TOOL WEAR COMPENSATION INPUTS WOM, WOP
GIVE N SIMULTANEOUSLY
Code Causes
085
EXTERNAL CM PERROR
MULTIPLICATION FACTOR SET BY PARAMETER
EXCEEDING 11 FOR EXTERNAL TOO LCOMPENSA
TION.
086
EXTERNALCMP ERROR
ERR OR IN PUT TURN ED ON DURING EXTERNAL
TOOL COMPENSATION.
087
PROG ERROR (G31~G35)
TOUCH SWITCH NOTON WHEN MOTION REACHES
END POINT BY SKIP OR TOOL SET ERROR
COMPENSATION COMMANDS
088
089
PROG ERROR (G90/G92/G94)
UNUSABLE ADDRESSES SPECIFIED IN
G90, G92, AND G94 BLOCKS.
090 PROG ERROR {G70.76/G72.78)
P,Q NOT COMMANDED IN G70,71,72,73 BLOCKS
091 PROG ERROR (G70-76/G72-78)
BLOCK OF SE OUENCE NO. SPECIFIED BY P,Q IN
G70 NOT FOUND PROG NO INCLUDING IN G70
BLOCK
.
092 PROG ERROR (G70-76/G72-78)
NO. OF BLOCKS INCLUDING FINISHED SHAPE
PROGRAM SPECIFIED BY ~,0 IN G70, G71, G72
AND G73, OVER 46.
093 PROG ERROR (G70-76/G72-78)
UNABLE G-AND M-CODE IN FINISHED SHAPE
PROGRAM SPECIFIED BY P,Q IN G70, G71, G72,
AND G73.
094 PROG ERROR IG70-76/G72-78)
BEVELING AND ROUNDING CO MM AN DS AS LAST
MOVE COMMAND FOR FINISHED SHAPE PROGRAM
SPECIFIED BY P,O IN G70, G71, G72, AND G73.
095
PROG ERROR !G70-76/G72-78)
FAULTS IN FINISHED SHAPE PROGRAM
SPECIFIED BY P, Q IN G71, G72
G29 COMMANDED IN FINISHING SHAPE PROGRAM
SPECIFIED BY P ANDQ IN G70, G71, G72, AND G73.
096 PROG ERROR (G70-761G72-78)
D (CUTTING FREQUENCY I SPECIFIED BY G73ZER0
OR 1280R MORE, 1, K I ROUGH CUT TIN GjSPECl -
FIED BY G73 BOTH ZFRO D, K OF G76 EXCEEDING
PROGRAMMABLE RANGE.