Code
Causes
097
PROG ERROR (G70-761G72-78)
FOUR OR MORE PROCESSING INTERRUPTIONS BY
FINISHED SHAPE PROGRAM IN STOCK REMOVAL
CYCLE BY G71 RI, OR G72 RI.
098
PROG ERROR (G70-76/G72-78)
DATA SPECIFIED BY G70P, Q NONREGISTERED
INTERNAL KEEP MEMORY.
099
PROG ERROR (G70-761G72-78)
UNUSABLE ADDRESSES SPECIFIED IN G70T0 G76
BLOCKS. ADDRESS REQUIRED IN THE BLOCK NO-
SPECIFIED.
100 CAL ERROR (FIXED POINT)
MAGNITUDE OF FIXED POINT DATA EXCEEDING
UPPER LIMIT.
101 CA LERROR (FLOATING)
EXPONENT OF FLOATING POINT DATA
EXCEEDING ALLOWABLE RANGE.
102
CAL ERROR (DIVISION)
~;~~{LATION DIVISOR ZERO OR OVERFLOW
103
CAL ERROR (SQUARE ROOT)
ROOT VALUE IS A NEGATIVE .’-
104
PROG ERROR (DOUBLE ADR)
CHARACTER WHICH CANNOT BE REPEATED INA
BLOCK COMMAND IN REPETITION.
105 MACRO ERROR (CONSTANT)
CONSTANT EXCEEDING THE LIMIT
106 MACRO ERROR
TOO MANY CODES FOR CA NC ELLING G67
107 MACRO ERROR (FORMAT)
ERROR IN THE FORMAT EXCEPT FOR EQUATION.
108 MACRO ERROR (U ND EFIN #NO.)
UNDEFINED VARIABLE NO. DESIGNATED.
r
Code
Causes
109
MACRO ERROR (# NO. NOT LEFT)
PRO HIBITED VA RI ABLE DESIGNATED AS
SUBSTITUTION.
110 MACRO ERROR ( [
1 5 LIMIT)
MULTIPLE LAYERS OF PARENTHESES
EXCEED DING THE UPPER LIMITS(5).
111 MACRO ERROR (MOVE G66-M99)
MOVE COMMAND IN M99 FINISHING COMMAND OF
MACRO CALLED BY G66.
112
MACRO ERROR
MULTIPLE LEVELS OF MACRO CALL EXCEEDING
THE UPPER LIMIT4.
113
114 MACRO ERROR (DO-FORMAT)
“DO” NOT CORRESPONDING TO “END.”
115
MACRO ERROR ( [ ] UN MATCH)
FORMAT ERROR IN <EQUATION>
116 MACRO ERROR (DO END NO. )
“m’’l ND OmOUTOFRANGEl~m<3
117
118
MACRO ERROR (GO TO N)
“n” In GO TO nO< n9999
APPROPRIATE SEQUENCE NO. NOT FOUND.
119
AS AFTER READ SUB PRO G/MACRO
ADDRESS SEARCHED DURING EXECUTION OF
SUBPROGRAM OR MACRO PROGRAM.
120 PRTN ERROR (NOT FOUND)
SEQUENCE NO. SEARCHED NOT FOUND IN PART
PROGRAM.
To Next Page
Loading...
