YASKAWA yasnac lx3

Code Causes
145 PROG ERROR (Gill/Gl12)
ERROR IN CO MM AN DIN G ADDRESS WORD FOR
G112 BLOCK.
146
PROG ERROR (Gill/Gl12)
ERROR IN COMMANDING PROGRAMMED SHAPE
FOR ME DBYG112 BLOCK.
147
148
149
150
PROG ERROR (G122/’Gl23)
G 122 AND G 123 CO MM AN D BLOCKS ARE NOT
INDEPENDENT COMMANDS. THE SAME TOOL IS
REGISTERED WITH MORE THAN TWO GROLJPS.
THE SAME OFFSET MEMORY NO. IS USED WITH
MORE THAN TWO TOOLS. ADDRESSES OTHER P, L
AND TARE lNSTRUCTE DTOTHE”rOLL
INFORMATION REGISTRATION PROGRAM.
151 PROG ERROR (G122/G123)
NO DESIGNATION OF GROUP NO. P IS GIVE N,OR A
VALUE OTHER THAN 1 ~PS191SGl VEN. NO
DESIGNATION OF LAS THE LIFE PER TOOL IS
GIVE N,OR A VALUE OTHER THAN 1SLS99991S
GIVEN.
152
PROG ERROR [G122/G123)
A VALUE OTHER THAN l< TOOL NO. S501S
INSTRUCTED AS THE TOOL NO. A VALUE OTHER
THAN 1 S COMPENSATION MEMORY NO. <501S
IN ST RUCTED AS THE COMPENSATION MEMORY
NO. VALUES OTHER OOR MORE THAN 20 ARE
INSTRUCTED AS:::;
T
(GROUP NO. ) COMMANDS OF
L;[u90T0T[:cj95 AND T[I[:99 COMMANDS.
153
PROG ERROR (G122/G123)
THE TOOL INFORMATION OF THE SAME GROUP
NO. IS REGISTERED TWICE.
154 PROG ERROR (G122/G123)
MORE THAN 16 TYPES OF “TOOL NO. +
COMPENSATION MEMORY NO. ” ARE ATTEMPTED
TO BE REGISTERED WI TH ONE GROUP NO.
155
PROG ERROR (G122/G123)
TOOLS OF THE DESIGNATED GROUP NO. ARE NOT
REGISTERED, T:::::: 92, T:::::: 93, T[::[::94 AND
T;::[::95 ARE INSTRUCTED, BUT THE
CORRESPONDING COMPENSATION MEMORY NOS.
ARE NOT REGISTERED.
156 PROG ERROR fG122/G123)
THE CO MM”AND FOR’ TOO L- LIF’E MANAGEMENT IS
ISSUSED WITH EQUIPMENT THAT DID NOT HAVE
THE ADDED FUNCTIONS OF “T4DIGIT
DESIGNATION” AND “OFFSET MEMORY
ADDITION, ”
Code
Causes
157 PROG ERROR (G122/’Gl23)
THE TOOL EXCHANGE REQUEST OUTPUT IS ON.
158
PROG ERROR (G122/G123)
THERE ARE TOOL NOS. THAT ARE MORE THAN
“31” WITH REGISTERED TOO LS. WJ,THIN TOOL
GROUP NOS. INSTRUCTED BY . . . ..OF WORK PIECE
COORDINATE SYSTEM SETTING (G 50 T:::::; 90).
159 PROG ERROR (G1221G123;
MORE THAN 6 TYPES OF COMPENSATION
MEMORY NOS. ARE REGISTERED WITH ONE TOOL.
170
MEM ERROR (OFS)
TOOL COMPENSATION TOTAL CHECK ERROR
171
172
MEM ERROR (SET)
SETTING AR EA TOTAL CHECK ERROR,
173 MEM ERROR (PRM)
PARAMETER AREA TOTAL CHECK ERROR.
174 ME ME RR OR (KEEP)
KEEP ME MO RY TOTAL CHECK ERROR.
—
175
MEM ERROR (M ACR)
MACRO TOTAL CHECK ERROR
176
177
178 TOOL NO. SET ERROR
TOOL NO. INPUT SIGNALS #1317 (D4T0 D7) #1342
(D4TOD6) ARE MORE THAN 51.
A–41