| Teams Device Settings | 30
• Connecting to an Available Wireless Network Manually
• Adding a Wireless Network manually
Connecting to an Available Wireless Network Manually
Before you begin
Get the password of the wireless network from your system administrator.
Make sure that the Wi-Fi mode is activated.
Procedure
1. Go to More > Settings > Device Settings > Wi-Fi (Admin only, default password: 0000).
2.
Select > Scan to search the available wireless network.
3. Select the desired wireless network.
4. If the network is secure, enter its password.
5. Select CONNECT.
Related tasks
Activating or Deactivating the Wi-Fi Mode
Adding a Wireless Network manually
If your gateway/router has SSID broadcast disabled, it might not appear in the scanning results. In that
case, you must manually add a wireless network.
Before you begin
Make sure Wi-Fi Mode is activated.
Procedure
1. Go to More > Settings > Device Settings > Wi-Fi (Admin only, default password: 0000).
2.
Select > Add.
3. Enter the SSID and then select a security mode from the Security drop-down menu:
• If you select None, select Save.
• If you select WEP or WPA/WPA2-PSK, enter the password and then select Save.
• If you select 802.1×EAP, select the desired EAP method and Phase-2 authentication, enter the
desired values in the Identity, Anonymous identity, and Password fields and then select Save.
If you enable Show advanced options, select a desired value in the Proxy field; and if you select
Manual, enter the information about the proxy server in the corresponding fields.
Related tasks
Activating or Deactivating the Wi-Fi Mode
Viewing the Wireless Network Information
After connecting to the wireless network, you can view the wireless network information (such as wireless
status, link speed, security, IP address, signal strength, and so on.)
Procedure
1. Go to More > Settings > Device Settings > Wi-Fi (Admin only, default password: 0000).
2. Select the connected wireless network.
To Next Page
Loading...
