Yealink SIP-T4 Series - Page 109

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 109 OF 150
Device-specific File: %BWMACADDRESS%.cfg
NOTE: This is an example file and it should be used for reference only.
#!version:1.0.0.1
##File header "#!version:1.0.0.1" can not be edited or deleted, and must
be placed in the first line.##
##This template file is applicable to SIP-
T21_E2P/T19_E2P/T23P/T40P/T27P/T29G/T46G/T48G/T42G/T41P/T48S/T46S/T42S/T41
S/T27G/T61/T66 IP phones running firmware version 72 or later.##
##For more information on configuration parameters, refer to Yealink_SIP-
T2_Series_T19P_T4_Series_IP_Phones_Auto_Provisioning_Guide.##
##########################################################################
#############
## Account1 Basic Settings
##
##########################################################################
#############
account.1.enable = %BWLINE-BINARY-1%
account.1.label = %BWEXTENSION-1%
account.1.display_name = %BWCLID-1%
account.1.auth_name = %BWAUTHUSER-1%
account.1.user_name = %BWLINEPORT-1%
account.1.password = %BWAUTHPASSWORD-1%
account.1.outbound_proxy_enable = %USE_SBC_BOOLEAN%
account.1.outbound_proxy.1.address = %SBC_ADDRESS%
account.1.outbound_proxy.1.port = %SBC_PORT%
account.1.dial_tone =
account.1.outbound_proxy.2.address =
account.1.outbound_proxy.2.port =
##It configures the transport type for account 1. 0-UDP,1-TCP,2-TLS,3-DNS-
NAPTR
##The default value is 0.
account.1.sip_server.1.transport_type = %TRANSPORT%
account.1.sip_server.2.transport_type = %TRANSPORT%
##########################################################################
#############
## Failback
##
##########################################################################
#############
account.1.naptr_build =
account.1.fallback.redundancy_type =
account.1.fallback.timeout =
account.1.sip_server.1.address = %BWHOST-1%
account.1.sip_server.1.port =
account.1.sip_server.1.expires =
account.1.sip_server.1.retry_counts =
account.1.sip_server.1.failback_mode =
account.1.sip_server.1.failback_timeout =
account.1.sip_server.1.register_on_enable =
account.1.sip_server.2.address =
account.1.sip_server.2.port =