Yealink SIP-T41S - Placing Calls Overview; Placing a Single Call

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 124 OF 150
account.2.codec.g726_40.priority =
account.2.codec.g726_40.rtpmap =
account.2.codec.ilbc.enable =
account.2.codec.ilbc.priority =
account.2.codec.ilbc.rtpmap =
account.2.codec.opus.enable =
account.2.codec.opus.priority =
account.2.codec.opus.rtpmap =
account.2.codec.pcmu.enable =
account.2.codec.pcmu.priority =
account.2.codec.pcma.enable =
account.2.codec.pcma.priority =
##########################################################################
#############
## Audio Advanced
##
##########################################################################
#############
##It configures whether to use voice encryption service for account X.0-
Disabled,1-Optional,2-Compulsory.
##The default value is 0.
account.2.srtp_encryption =
##It configures the RTP packet time for account X.0 (Disabled), 10, 20,
30, 40, 50 or 60.
##The default value is 20.
account.2.ptime =
## The default value is 0(Take a SRTP all encryption).1:Only carry AES -
80 secret key,2: Only carry AES - 32 secret key
##########################################################################
#############
## Anonymous Call
##
##########################################################################
#############
account.2.send_anonymous_code =
account.2.anonymous_call =
account.2.anonymous_call_oncode =
account.2.anonymous_call_offcode =
account.2.reject_anonymous_call = %REJECT_ANONYMOUS_CALL_BINARY%
account.2.anonymous_reject_oncode =
account.2.anonymous_reject_offcode =
account.2.send_anonymous_rejection_code =
##########################################################################
#############
## Pickup Code
##
##########################################################################
#############
##It enables or disables the phone to pick up a call according to the SIP
header of dialog-info for account X.0-Disabled,1-Enabled.
##The default value is 0.
account.2.dialoginfo_callpickup =
##It configures the group pickup code for account X.
##The default value is blank.
account.2.group_pickup_code = %BWFAC-CALL-PICKUP-2%