Yealink SIP-T46S - Page 86

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 86 OF 150
#dialplan_dialnow.url =
http://%BWDEVICEACCESSFQDN%:%BWDEVICEACCESSPORT%/%BWDMSCONTEXT%/%BWDEVICEA
CCESSURI%dialnow.xml
phone_setting.dialnow_delay =
#dialplan_replace_rule.url =
http://%BWDEVICEACCESSFQDN%:%BWDEVICEACCESSPORT%/%BWDMSCONTEXT%/%BWDEVICEA
CCESSURI%dialplan.xml
##########################################################################
#############
## Remote Phonebook(Except T20P Model)
##
##########################################################################
#############
###X ranges from 1 to 5
###remote_phonebook.data.X.url =
###remote_phonebook.data.X.name =
remote_phonebook.data.1.url =
remote_phonebook.data.1.name =
###Except T41P/T42G Models
remote_phonebook.display_name =
###It enables or disables the phone to update the data of the remote phone
book at a time when accessing the remote phone book.
###0-Disabled, 1-Enabled. The default value is 0.(Except T19P/T21P Models)
features.remote_phonebook.enter_update_enable =
##It enables or disables the phone to perform a remote phone book search
when receiving an incoming call.
##0-Disabled,1-Enabled.
##The default value is 0.
features.remote_phonebook.enable =
##It configures the interval (in seconds) for the phone to update the data
of the remote phone book from the remote phone book server.
##The value 0 means the phone will not regularly update the data of the
remote phone book from the remote phone book server.
##The default value is 21600.Integer from 3600 to 2592000,and 0.
features.remote_phonebook.flash_time =
##########################################################################
#############
## LDAP(Except T19P/T20P Models)
##
##########################################################################
#############
##It enables or disables LDAP feature.0-Disabled,1-Enabled.
##The default value is 0.
ldap.enable =
##It configures the criteria for searching the contact name attributes.
##Example:ldap.name_filter = (|(cn=%)(sn=%)).
##The default value is blank.
ldap.name_filter =
##It configures the criteria for searching the contact number attributes.
##Example:ldap.number_filter = (|(telephoneNumber=%)(mobile=%)(ipPhone=%))
##The default value is blank.
ldap.number_filter =