Yealink SIP-T46S - Page 92

BROADSOFT PARTNER CONFIGURATION GUIDE – YEALINK T4X IP PHONE 20-BD5476-00
©
2017 BROADSOFT INC. PAGE 92 OF 150
## Phone Settings
##
##########################################################################
#############
phone_setting.inter_digit_time =
phone_setting.ring_type =
phone_setting.ring_for_tranfailed =
phone_setting.is_deal180 =
phone_setting.show_code403 =
###Only T41P/T42G/T46G Models support this parameter
phone_setting.page_tip =
phone_setting.predial_autodial =
phone_setting.headsetkey_mode =
features.voice_mail_tone_enable =
##Except T19P/T21P Models support this parameter
static.phone_setting.reserve_certs_enable =
phone_setting.called_party_info_display.enable =
phone_setting.call_info_display_method =
##########################################################################
#############
## Power Led Settings
##
##########################################################################
#############
phone_setting.common_power_led_enable =
phone_setting.talk_and_dial_power_led_enable =
phone_setting.mail_power_led_flash_enable =
phone_setting.ring_power_led_flash_enable =
phone_setting.mute_power_led_flash_enable=
phone_setting.hold_and_held_power_led_flash_enable =
##It configures the level of the active backlight intensity.
##For SIP-T28P IP phones and the connected EXP39:
##The default value is 2.
##For SIP-T46G IP phones and the connected EXP40:
##The default value is 8.
phone_setting.active_backlight_level =
##It configures the phone to go out or reduce intensity of the backlight
on the LCD screen after a period of inactivity.
##0-Off,1-Low.
##The default value is 1.
###Only T46G/T48G Models support this parameter
phone_setting.inactive_backlight_level =
##########################################################################
#############
## Phone Setting Display
##
##########################################################################
#############
###Except T20P/T19P/T21P Models
##It configures the backlight time (in seconds).0, 1, 15, 30, 60, 120,
300, 600 or 1800.
phone_setting.backlight_time =