end the call and you need to deactivate the speakerphone before hanging up.
3.Hold (Hold Function)
To place a call on hold during a conversation press the Hold soft key which will deactivate the microphone of
the phone. The other party hears a “hold melody”.
If you have one single call on hold, to resume the conversation and reactivate the microphone of the phone,
just press the Resume soft key. If multiple calls are on hold, you must first select the call on hold using the
up/down directional key and then press the Resume soft key.
4.Deactivating the Microphone (Mute Function)
To deactivate the microphone during a conversation or a conference call, press the key. The display will
show the icon.
To reactivate the microphone of the phone, press the key again.
5.Call transfer
There are two ways to transfer a call: blind transfer where the number to transfer the call cannot decide
whether or not to accept the call transfer or the hold call transfer, where this option is available.
5.1 Blind transfer
During a conversation press the key to place the incoming call on hold. At this point you will hear a
dial tone and you can enter the number of the person to transfer the call to and press again the key to
transfer the call. The call is then transferred and you are disconnected from the previously call placed on
hold.
5.2 Transferring with call waiting
During a conversation press the key to place the incoming call on hold. At this point you will hear a
dial tone and you can enter the number of the person you want to transfer the call to.
4/9
To Next Page
Loading...
Need help?
General
