Level 1 21 Shierlaw Ave Canterbury 3126, Victoria, Australia
Configuring Yealink T42G
1. View and record the unique MAC address of the base station which can be found at
the rear of the base station. (Alternatively via the Handset)
Network Settings
You can configure the base station to obtain network settings in one of the following ways:
DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain the valid
network settings, e.g., IP address, subnet mask, gateway address and DNS address
STATIC: If the phone cannot contact a DHCP server for any reason, you need to configure the IP
address, subnet mask, gateway address, primary DNS address and secondary DNS address for the
phone manually.
To Next Page
Loading...
