Yealink T46G

Basic Call Features
You can place an active call on hold. Only one active call can be in progress at any time.
Other calls can be made and received while placing the original call on hold. When you
place a call on hold, your IP PBX may play music on hold to the other party while
waiting.
To place a call on hold:
1. Press or the Hold soft key during a call.
The LCD screen indicates that the call is on hold.
The line key LED flashes green. The phone will beep softly every 30 seconds to remind
you that you still have a call on hold.
To resume a held call:
1. Press or the Resume soft key.
Multiple Calls on Hold:
If multiple calls are placed on hold, do one of the following:
- Press or to switch between the calls, and then press the Resume soft key
to retrieve the desired call.
- Press the corresponding line key to retrieve the call.
If more than two calls are on hold, a numbered prompt appears on the LCD screen, for
example "2/4", indicating that this is the second call out of four calls.
You can use DND to reject incoming calls automatically on the phone. Callers will
receive a busy message.
You can enable/disable DND for the phone system, or you can customize DND for each
or all accounts. Two DND modes:
 Phone (default): DND is effective for the phone system.
 Custom: DND can be configured for each or all accounts.
You can receive incoming calls from authorized numbers when DND is enabled.