YOKOGAWA PH402G - Page 44

5-12 Parameter setting
IM 12B6B3-E-H
YES
NO
NO
pH
ENT
pH
YES
ENT
YES
ENT ENT
ENT
Note: Range 2 does not
appear when P1 control
set on mA2
Range Selection Options
are determined
by Service Code 31
ENT
ENT
Choose Range to adjust, then set begin scale (0%)
and end scale (100%) of the mA output signal, using
the >, ,and ENT keys. Selection of mA output
(0-20 / 4-20 mA) is in Service Code 30.
>
ENT
Range values set, return
to commission mode.
YES
NO
YES
NO
YES
NO
YES
NO
YES
NO
OR
YES
Note: Range 2 does not
appear when PI control
set on mA2