5-34 Parameter setting
IM 12B6B3-E-H
5-3-9. Test and setup mode
Code 80 *TEST The test mode is used to confirm the instrument setup. It is based on the factory
setup procedure and can be used to check the QIC (factory generated test certifi-
cate). To use this test feature it is necessary to have the detail provided only in
the QIS (Quality Inspection Standard) or the Service manual.
NOTE: attempting to change data in service code 80 and above without the proper instructions and
equipment, can result in corruption of the instrument setup, and will impair the performance of the
unit.
To Next Page
Loading...
Need help?
General
