YOKOGAWA TY710 User Manual

104
<Defaultsettingofnumberdisplay/timedisplayduringLOGGINGmode>
Set the sub-display during LOGGING mode.
(The numbers of saved data or time (minute : second))
Default is the numbers of saved data.
1)PressingtheLIGHTkeyshows“LG.Unt”onthedisplay.
HOLD
：No.
：CLOCK
2)Selectthedesiredsettingbyusingthe▲(RANGE)keyor▼(REL)key.
3)PresstheHOLDkeytosavethesetting.
 “SEt”appearsandthen“LG.Unt.”
<Soundon/offsetting>
Set the sound on/off (beep of buzzer)
Even if the user sets the sound off, it goes off at the following points.
• checkingcontinuity
• alarmforover-input
• alarmforautopower-off
1) Pressing the LIGHT key shows “bEEP” on the display.
Set on/off on the sub-display. Default is ON.
HOLD
: ON
: OFF
2)Selecton/offbyusingthe▲(RANGE)keyor▼(REL)key.
3)PresstheHOLDkeytosavethesetting.
“SEt” appears and then “bEEP.”
<Reset to factory preset mode>
Reset all the settings to factory preset mode except for time.
1) Pressing the LIGHT key shows “dEF.” on the display.
HOLD
2) Press the HOLD key to reset the settings.
“donE” appears and then “dEF.”

YOKOGAWA TY710 Specifications

General

Brand	YOKOGAWA
Model	TY710
Category	Multimeter
Language	English