<2. Handling Precautions>
7
IM 01F07A01-02EN
2. HANDLING PRECAUTIONS
This section describes the precautions to follow when handling the product. Be sure to read this
section before using the product. For information other than that described in this section, refer to
the related section.
If you have any problems or questions, contact your nearest YOKOGAWA service center or sales
representative.
2.1 CheckingModelandSpecications
This instrument is inspected thoroughly before it is shipped from the factory. When this
instrument is delivered to the installation site, check its external appearance for damage, and
make sure that all parts for installation are provided.
Be sure that you have your model number (MODEL) and serial number (No.) available when
contacting Yokogawa.
The model code and specications given on the nameplate are those current when this product
was shipped from the factory. It is not possible to change the nameplate after shipment.
Figure 2.1(a) Example of Nameplate (Integral Type)
Remote sensor
Remote transmitter
Figure 2.1(b) Example of Nameplate (Remote Type)
To Next Page
Loading...
Need help?
General
