To Next PageTo Next PageWhat to do if the signal is not outputted from the output terminal of Yokota WU-1 Controller?
If the signal is not outputted from the output terminal, check for improper connection on the terminal block, ensuring the numbers match with the unit. Verify the settings of output terminals and replace the cable for external signal if it is broken.
Why is my Yokota WU-1 Controller DS-1 not operating?
If the DS-1 does not operate, ensure that the wireless unit is turned on and that the cable is properly connected. If the issue persists, the cable may be broken and need replacement.
Why is my Yokota WU-1 Controller PC-1 not operating?
If the PC-1 does not operate, ensure that the wireless unit is turned on and that the cable is properly connected. If the issue persists, the cable may be broken and need replacement.
General| Brand | Yokota |
|---|---|
| Model | WU-1 |
| Category | Controller |
| Language | English |
Precautions for safe electrical usage, avoiding shocks and fires.
Steps to configure the PC's IP address for network connection.
Instructions to open Internet Explorer to access the device's settings.
How to enter the IP address and select the unit for configuration.
Steps to read existing settings and write modified values, including error handling.
Mapping functions like WORK, PASS, or RESET to specific input terminals.
Mapping output signals like NG, OK, or WORK finish to specific output terminals.
Configuration options for baud rate and parity in serial communication.
Setting IP address, subnet mask, and port number for LAN communication.
Solutions for issues related to power indication and failure to enter pairing mode.
Troubleshooting steps for when the tool does not operate or pairing fails.
Resolving issues with input/output signals, DS-1/PC-1 operation, and communication failures.
