Yolink FlexFob User Manual

33
FlexFob Settings: Control-D2D,
Continued
Q
Unpair your FlexFob:
1. On the FlexFob, press the assigned button for
10 to 15 seconds, until the LED flashes green,
then red, then release the button.
2. On the Garage Door Controller, press and hold
the SET button for 10 to 15 seconds, until the
status LED flashes green, then red.
The Garage Door Controller should no longer
respond to the FlexFob. Test the fob and perform
the unpairing steps again, if needed.

Yolink FlexFob Specifications

General

Brand	Yolink
Model	FlexFob
Category	Remote Control
Language	English