York CURBPAK CP23 - WIRING DIAGRAM 2 SPEED - 2 WINDING STARTER PANEL

YORK INTERNATIONAL
30
Installation
NOTES: 1. Connect remote control signal for slow speed at Terminals 1 & 2. Dry control contact rated at min. 2A / 115V.
2. Connect remote control signal for fast speed at Terminals 3 & 4. Dry control contact rated at min. 2A / 115V.
3. Connect remote control signal for motor stop/start at Terminals 5 & 6.
4. Install safety between Terminals 7 & 8. Remove Jumper J1 accordingly.
5. TB not installed if internal rotary (thru-the-door) disconnect is present.
6. Time delay relay, to adjustable.
480V
3T
120V
(OPTIONAL SINGLE-POINT
LIGHT CIRCUIT)
WIRING DIAGRAM
2 SPEED – 2 WINDING
STARTER PANEL
LD06282
FIG. 34 – WIRING DIAGRAM