York HIDS006B21S - Removing Fan And Fan Motor From Bottom Side (For All Models)

(Ducted Slim Type)
MAINTENANCE
4-30
SM-18001-rev.1
4.2.3.3 Removing Fan and Fan Motor from Bottom Side (For All Models)
(1) Remove the electrical box cover according to Section 4.2.3.2. “Removing PCB”.
(2) Disconnect the connector for the fan motor located on the PCB2. Then remove the wiring.
(3) Remove the lower M4 screws securing the inlet ange.
Qty. of Screws (A): Three (For (H,Y,C)IDS006 - 012B21S)
Four (For (H,Y,C)IDS015 - 018B21S)
Phillips ScrewdriverTool
Phillips ScrewdriverTool
M4 Screws (x (A))
Inlet Flange
M4 Screws (x (B))
Lower Cover
(4) Remove the lower M4 screws securing the lower cover at the indoor fan side and remove the lower
cover.
Qty. of Screws (B): Seven (For (H,Y,C)IDS006 - 012B21S)
Eight (For (H,Y,C)IDS015 - 018B21S)
TURN OFF all POWER supply switches.