York HIDS006B21S - Page 153

SM-18001-rev.1
5-23
EXTERNAL INPUT/OUTPUT AND FUNCTION SETTING
*1): The“02”settingmaynotbeavailableaccordingtothetypeofindoorunit.
*2): Incasethatthesettemperatureischangedandthetemperatureiskeptforaspecictimesetby“F4”,it
automaticallychangestothetemperaturesetby“F5”or“F6.”(Incasethatthesettemperatureof“F5”and“F6”
isoutofrange,theupperorlowerlimittemperatureisapplied.)
*3): Applicabletofan,coolinganddryoperationmodes.
*4): Applicabletoheatingoperationmode.
*5): Operationisstoppedbypressingthe“
”(On/Off)buttonfor3seconds.
*6): Thesensorvalueat“C8”isindicated.Whenthethermistorforwiredcontrollerisused,theaveragevalueof
thethermistorforwiredcontrollerandthethermistorforindoorinletisindicated.
*7): Whentheunitisrestartedbythewiredcontroller,thetemperatureautomaticallychangestothesetting
temperatureof“F5”or“F6”.
*8): Besuretouseonlythe"00"settingconditionwhencombiningoptionalfunctionsettings,"q4"and"q5,"with
awatersourceunit.Thewatersourceunitdetectsenteringwatertemperatureinsteadofoutdoorambient
temperature.Thissettingdoesnotfunction.
No. Items Optional Function
Individual
Setting
Setting
Condition
Contents
144 S5 Not Prepared - - Not Used
145 S6 Not Prepared - - Not Used
146 S7 Not Prepared - - Not Used
147 S8 Not Prepared - - Not Used
NOTES:
1. Waitatleast3minutesfrominitialpowerONtochangetheoptionalsetting.
2. Whenchanging“CF”setting(“ChangeofLouverSwingAngle”),restorethepowersupplyortestthelouver
swingacoupleoftimesintheautoswingmodetovalidatethesetting.
3. Theoptionalsettingsaredifferentaccordingtotheindoorandoutdoorunitmodels.
Checktoensureiftheunithastheoptionalsettingornot.
4. Theaboveoptionalfunctionswith“X”markattheindividualsettingcanchangetheconditiononlywhen“All
Rooms”isselectedintheTestRunMenu>FunctionSelectionMenu.
5. Functionselectionitems"L9"and"q1"to"S8"areavailableonlyforindoorunitsandwiredcontrollerswith
newsoftwareapplied.Checktoensureiftheunithastheoptionalsettingornot.