YORK INTERNATIONAL
92
OPTIONAL TAMPERPROOF ENCLOSURE
(WIRE GRILLE)
General
A wire grille tamperproof enclosure is available for the
chiller for the prime purpose of deterring unauthorized
access to components on the chiller.
Kits 475-04251-002 is the tamperproof enclosure which
consists of weather resistant steel grilles as well as the
necessary mounting hardware. Two kits must be in-
stalled to complete the installation.
Installation For Master Section
1. Refer to Fig. 43 and the associated parts list. Before
starting installation, all of the items in the kit should
be identified by comparing with Fig. 44.
2. All holes for mounting kit parts are provided in both
the chiller frame and the added supports; therefore,
it should be unnecessary to drill holes.
3. Install grilles using the proper hardware and supports.
Refer to Fig. 44 and the Parts List for placement of
the grilles and the proper hardware required.
4. Notch grilles to suit water connection and wiring har-
nesses as needed.
5. If the High Ambient Sunshield Kit or Disconnect Op-
tion is installed, field adaption will be required where
parts of the kits interfere. Touch up exposed metal
parts to prevent rust.
0001TG
FIG. 43 COMPLETED INSTALLATION
FIG. 53 WIRE GRILLE INSTALLATION FOR EACH KIT
PART # ITEM QTY DESCRIPTION
075-02501-000 1 6 BRACKET
075-02502-000 2 24 CLIP (SINGLE)
075-02503-000 3 4 CLIP (DOUBLE)
025-32206-000 4 1 GRILLE
026-31834-000 5 8 GRILLE
026-31633-000 6 8 GRILLE
026-32207-000 7 1 GRILLE
021-16203-000 8 145 SCR. TAP TYPE F 1/4 x 3/4 LG.
021-16165-000 9 145 WASH FLAT 1/4
021-16205-000 10 60 SCR. HEX HD. 3/8 x 1-1/2 LG.
021-16158-000 11 60 LOCKWASHER, SPG. 3/8
021-16139-000 12 60 NUT, HEX. 3/8
Parts List for Each Kit
LD01953
To Next Page
Loading...
